If you remove the key too soon, the key may no longer be visible in Admin Control Center. The latest Command Line HASP driver, can be found on the following page: Sentinel HASP/LDK Windows Command Line Run-time Installer NOTE : If deploying E-Prime 3.0 Update 3 via msi or lowercase setup.exe, you must use a command line installer to install the Provisional License. Do not remove the key while it is blinking. %ProgramFiles(x86)%\Thales\Sentinel LDK\Redistribute\Firmware Update\HASP HL\ĭuring the Firmware upgrade, the relevant key will start to blink. This is located on the machine where Sentinel LDK Vendor Tools are installed, in the directory: Customers can upgrade the Firmware to version 3.25 by applying the Firmware Update V2C. (You can determine the firmware version of your HL key by viewing the key on the Sentinel Keys page of the Admin Control Center.)įor HL keys with Firmware earlier than version 3.21, the upgrade does not occur automatically. >when a customer connects a HASP HL key with version 3.21 firmware to a computer where the Run-time Environment version 2.0 or later has been previously installed. >when a HASP HL key with version 3.21 firmware is present on a computer where the Run-time Environment is being updated to version 2.0 or later.

Sentinel LDK automatically upgrades the firmware on HASP HL keys from version 3.21 to the latest version (3.25). The legacy HASP HL Key firmware has been modified to support future planned security enhancements in Sentinel LDK.